Magnetic Properties of Fe$_2$CrGa Heusler Alloy Films
Yu. V. Kudryavtsev, V. O. Golub, A. O. Perekos, T. G. Kabantsev, M. P. Melnyk, and V. Yu. Tarenkov
vol. 45, pp. 431-441 (2023)

Effect of Atomic Substitutions on the Electronic Structure of Pt$_{1-x}$$Me$$_{x}$MnSb ($Me$ = Ni, Cu; $x$ = 0.0–1.0)
V. M. Uvarov, M. V. Uvarov, and M. V. Nemoshkalenko
vol. 45, pp. 443-456 (2023)

Increasing the Damping Capability of Titanium Alloys by Deposition of Plasma Coatings Made from Titanium Nickelide
Yu. O. Kazymyrenko, N. Yu. Lebedeva, and T. O. Makrukha
vol. 45, pp. 457-466 (2023)

Experimental Study of Energy-Power Parameters of Billet Rolling of Compressor Blades of Aircraft Engines
V. V. Chigirinsky, Y. S. Kresanov, and I. E. Volokitina
vol. 45, pp. 467-479 (2023)

Corrosion Properties Characterization of 06Cr18Ni10Ti, 08Cr18Ni10Ti Steels and 42CrNiMo Alloy under Conditions Simulating Primary Coolant of Pressurized Water Reactor
V. A. Zuyok, R. A. Rud, M. V. Tretyakov, N. V. Rud, Ya. O. Kushtym, and V. V. Shtefan
vol. 45, pp. 481-501 (2023)

Influence of Technological Parameters on the Physical, Mechanical and Operational Properties of Wear-Resistant Austenitic High-Manganese Steel
V. M. Sazhnyev and H. V. Snizhnoy
vol. 45, pp. 503-522 (2023)

Ultrasonic Investigation of High-Entropy Al$_{0.5}$CoCrCuFeNi Alloy at Low Temperature
V. S. Klochko, A. V. Korniyets, I. V. Kolodiy, O. O. Kondratov, V. I. Sokolenko, V. I. Spitsyna, T. M. Tykhonovska, and N. A. Yayes
vol. 45, pp. 523-535 (2023)

Comparative Analysis of the Structure, Phase Composition and Properties of High-Entropy Cermets of Ti–Cr–Fe–Ni–C System Obtained by Powder Metallurgy and Arc Remelting Methods
H. A. Bagliuk, M. V. Marich, S. F. Kirilyuk, O. M. Myslivchenko, O. A. Golubenko, and O. S. Makarenko
vol. 45, pp. 537-553 (2023)

Film Hardness Evaluation in Hard Film/Substrate Composites by Conical Indentation
A. Boudilmi and K. Loucif
vol. 45, pp. 555-567 (2023)